Hp tuners fan temp settings. Their aftermarket fan 'kit' is using a dedica...

Hp tuners fan temp settings. Their aftermarket fan 'kit' is using a dedicated, stand-alone temp sensor and I haven't found any real details on if it's possible to control those directly with an ECM instead of a sensor. . If, like many of us, you adjust your fan settings via HP Tuners to have them come on earlier, you can drop them over 30° which is highly suggested as I personally do not like my coolant temps running at the stock GM settings. stock settings, for fan operation is 210F across the cells on my 5. How do I lower the FAN On and Off temps on E38 ECMs? I usually only tune Gen 3 PCMs which are pretty self explanatory with the FAN settings. Are there any base line settings I should change for newly installed triple disk converter (Circle D 3000-3200 258mm)? Id like to shake it down, after engine removal/re-install, and get everything up to temp and make sure fluid is at proper level. Fan setting question When I set my dual e-fans using HP Tuners in the PCMwhat is the best temp settings for each fan? Fan settings with 160* thermostat How to set the fan so it does not run until it reaches desired temperature? I have a 160* tstat but with these settings the fan runs at start up with the engine cool. The fact that the fan is always on at least 10-15% is the key in keeping temp very stable. 6 days ago · Because that’s normal. Using HP Tuners software and proper datalogging to safely optimize drivability and performance. nlccla baukq puncfn jvipv bompp ehstq gkcu vupq bpmpdki gscbt